Go to Free Shipping Info

 

    BIKE ACCESSORIES
 Bike Stands
 Body Kits
 Bolt Kits
 Cargo Racks
 Digital Gauges
 Fender Packs
 Footpegs
 Gas Tanks
 Kickstands
 Motorcycle Luggage
 Seats
 Lift Straps
    DRIVE / BRAKES
 Rekluse Clutches
 Chain Adjusters
 Brake Discs
 Brake Pads
 Chains
 Left Hand Rear Brakes
 Sprockets
    ELECTRICAL
 Batteries
 Battery Chargers
 Dual Sport Kits
 Lighting Kits - KTM
 Led Lights
 Switches
 Turn signals
    ENGINE
 Air Filters
 Rekluse Clutches
 Jetting Kits
 Fuel Filters
 Fuel Injection Tuners
 Oil Filters
 Valve Shim Kits
    EXHAUST
 Spark Arrestor Endcaps
 Header Pipes
 Heat Shields - KTM
 Mufflers / Silencers
 Pipeguards
    HANDLEBAR CONTROLS
 Bar End Mounts
 Deflectors
 Grip Heaters
 Grips
 Handguards
 Left Hand Rear Brakes
 Levers
 Mirrors
 Steering Stabilizers
 Switches
 Throttle Cables
 Throttle Cam Systems
    PROTECTION
 Clutch Slave Cylinder
 Disc Guards
 Handguards
 Pipe Guards
 Radiator Guards
 Skid Plates
    RIDER GEAR
 Basegear
 Boots
 Drink Systems
 Fanny Packs
 Gloves
 Helmets
 Jackets
 Jerseys
 Pants
    SUSPENSION
 Fork Seal Doctor
 Fork Seal Protectors
 Seals / Bearings
 Steering Stabilizers
    TOOLS
 Motion Pro Tools
 Pocket Chainsaw
 Rim Locks
 Spoke Torque Wrench
 TiProlight Wrenches
 Tire / Chain Tools
 Tire Changing Stand
 Tire Levers
 Tool Packs

Authorized Dealer for:



Go to BlueRibbon Coalition Website
 
Tugger Lift Straps
The Tugger Lift Strap provides a convenient gripping point near the front or rear of your dirt bike. Most dirt bikes don't have a place to grab that won't toast your fingers or get your gloves all muddy.

The Tugger is ready when you need it and stays out of the way when you don't. Perfect on the trail when you need to maneuver your bike over a rock, around a tight switchback or get it out of a deep rut. No more burning your hand on your hot silencer, getting your gloves covered in mud from grabbing the rear fender or breaking the fenders because you used them as a handle.
a
Easy to install, lightweight, tough, and convenient. Fits nearly any motorcycle that uses two bolts to attach the seat to the subframe (16" max length between the bolts).

The front Tugger mounts to the front forks, providing a handy place to grab when you get in those situations where someone else is pulling on your bike. And for you adults riding with your child, the front Tugger is especially handy for helping your child through nasty situations.

Enduro Engineering
Grab Handles

    Availability Guide: If you order an item that is not in stock, we will not charge your card until the order is ready to ship.

      = Normally ships the same business day      = Ships in 1 to 2 business days      = Backordered from supplier
  Tugger Lift Straps - Combo Cost Add To Cart
Tugger Extreme Lift Strap - Combo
Includes Rear Tugger (Tugger-1) and Front Extreme Tugger (Tugger-2X)
Part No. Tugger-12X

$42.99
MSRP $44.99
 
Rear Bolt-on Tugger and Front Tugger - Combo
Includes Rear Tugger (Tugger-1) and Front Tugger (Tugger-2)
Part No. Tugger-12

$37.99
MSRP $39.98
 
  Tugger Lift Straps - Rear Cost Add To Cart
Style 5 Rear Tugger Husqvarna
Fits 2017-18 Husqvarna + FC 2016
Attaches to the subframe and installs in minutes. Includes mounting hardware.
Tugger-5
$11.99
 
Style 1 Rear Tugger Extreme Enduro (New style with stainless steel buckles)
Fits nearly any motorcycle that uses two bolts to attach the seat to the subframe (16" max length between the bolts).
Tugger-1
Application Chart
$24.99
 
Rear Tugger (Slip-on)
Fits bikes that mounts to the subframe extensions found under the rear fender
Tugger-3
Application Chart
$14.99
 
  Tugger Lift Straps - Front Cost Add To Cart
Style 6 Triple Clamp Tugger
Built at the request of snow bikers, this mounts to the top triple clamp and extends vertically above the handlebar to provide a convenient location to grab your snow bike even when buried in the white stuff.
Tugger-6
$24.99
 
Style 2 Front Tugger Extreme Enduro (New style with stainless steel buckles)
Fits all bikes - mounts to the front forks. The Extreme Enduro version is thicker where you grab and has a non-slip covering to handle the worst abuse.
Tugger-2X
$19.99
 
Style 2 Front Tugger Original Design
Fits all bikes - mounts to the front forks. Includes handle on strap.
Tugger-2
$13.99
 

Larger Images

Tugger Lift Strap - Larger Images

Style 5 - (for 2017-18 Husqvarna + FC 2016) mounts to the subframe of 2017-18 Husqvarna models. Easy to install, lightweight yet rugged. Weight: 1.1 oz, includes mounting hardware.

Style 1

Style 1 Rear Tugger Extreme Enduro - An upgrade from the original Style 1 rear Tugger, the "Extreme Enduro" version has stainless steel buckles on the webbing assembly instead of aluminum. Fits most dirt bikes. Easy to install, lightweight, tough, and convenient. After riding with the Tugger™, you'll never want to ride without one again. Weight: 1.8 oz with typical mounting hardware! (That's less than 1/8 of a pound!)

Style 1 Rear Tugger Extreme Enduro

Style 1 - 2009 KTM mount

Style 1 - KTM with sub fender mount Style 1 - Most bikes mounts like this

Style 6

Style 6 Triple Clamp Tugger - Built at the request of snow bikers, the Style 6 Triple Clamp Tugger mounts to the top triple clamp and extends vertically above the handlebar to provide a convenient location to grap your snow bike even when buried in the white stuff. Constructed using two layers of Tugger webbing with an internal stiffener to handle the worst abuse. Easy to install, lightweight, tough, and convenient. Backed by our no-nonsense After riding with the Tugger™, you'll never want to ride without one again. Weight: 3 oz!

INSTRUCTIONS:
1. Remove one top triple clamp bolt. Use the top bolt for max height, the lower one if you want the Tugger a little lower.
2. Decide if the stock bolt can be used; if not, use one of the bolts included in your Tugger kit. You may need to cut the bolt a little shorter for some models.
3. Slide the Tugger metal end piece over the aluminum bushing, insert the bolt and tighten.
4. Route the Tugger as desired and repeat on the other side.

Style 2 Front Tugger Extreme Enduro

Style 2 Front Tugger Extreme Enduro - An upgrade from the standard Style 2 front Tugger, the Extreme Enduro version is thicker where you grab and has a non-slip covering to handle the worst abuse. It retains the simple and effective buckle attachment system that allows installation on any forks without tools. Because of the extra thickness, custom embroidery is not available. Like the original Style 2, the Style 2 Tugger™ Extreme Enduro mounts to the front forks, providing a handy place to grab when you get in those situations where someone else is pulling on your bike. You hard-core enduro riders will love it!

And let's face it: we all get into nasty situations occasionally - that's part of the fun! Watch this video and you'll see what we mean: Extreme Enduro video The tire is slippery and muddy and will cause a loop-out if you're on a hill because you're lifting as well as pulling. The fender is also too slippery and muddy, and most handlebars don't have a crossbar to grab. The Style 2 Tugger™ comes in handy in the nastiest of situations or even just loading your machine into the truck. The front Tugger™ is made from the finest materials available. Like the rest of the Tugger™ line, it is built to work well, look good, and last. Installed weight: 2.2 oz!

Style 2 Front Tugger Extreme Enduro

Front Tugger - Tugger 2

Rear Tugger (Slip-on) - Tugger 3 Tugger 3 - mount location

Tugger 3 - 2009 KTM SX mount location (remove rear fender, slide Tugger 3 over subframe stubs, install fender)

Rear Tugger (Slip-on) - Tugger 3


 
 
 

       SHOP BY BRANDS
Go to Acerbis Products
Go to All Balls Racing
Go to Alpinestars offroad and motocross Boots Page
Go to ARC Composite Levers
Go to Micro-Start Power Supply Kit
Go to Arai Helmets
Go to Battery Tender products
Go to BikeMaster Products
Go to Bolt Motorcycle Hardware Products
Go to BRP Page
Go to Bullet Proof Designs
Go to Clarke Manufacturing Gas Tanks Products
Go to CV4 Cooling Products
Go to Cycra Racing Products
Go to DID Racing Chains
Go to Dirt Tricks Products
Go to EBC Brakes
Go to ELine Skid Plates
Go to Enduro Engineering Products
Go to Fasst Company Products
Go to Fastway Products
Go to FMF Products
Go to Flatland Racing Products
Go to G2 Ergonomics Products
Go to Giant Loop Motorcycle Luggage
Go to Hammerhead Products
Go to Heat Demon Handlebar Grip warmers
Go to HiFlo Oil Filters
Go to HotCams Products
Go to IMS Gas Tanks
Go to Ironman Sprockets Products
Go to JD Jetting Products
Go to JT Sprockets
Go to Klim Technical Riding Gear Products
Go to Leatt-Brace Products
Go to Moose Racing Products
Go to Motion Pro Tools
Go to No-Toil Products
Go to Ogio Hydration Back Packs, Flight Vest, Toolbag, and Accessories
Go to Ohlins Steering Stabilizers
Go to Pivot Works Seals and Bearings
Go to Pocket ChainSaw - The World's Fastest Cutting Pocket Saw
Go to Pro Moto Billet Products
Go to ProTaper Grips
Go to Ram Mounts
Go to Rekluse Products
Go to Renthal Sprockets and Chains
Go to Scotts Performance Page
Go to Seat Concepts - Complete Seats and Comfort Seat foam and Cover
Go to Shock Sox Removable Fork Seal Protector
Go to Shorai Batteries
Go to Trail Tech Products
Go to Tubliss Products page
Go to Tugger Products

 
 
 
          © 1998 - 2017 CycleBuy.com, All rights reserved. / Order Policies / Privacy Policy
Unauthorized use of any images, descriptions, or editorial content without permission is strictly prohibited.
Address:  1116 S Commercial Way SE, Albany, Oregon 97322 U.S.A.